Research could dramatically lower cost of electron sources
Artist's representation of a halide perovskite photocathode. Researchers at Rice University and Los Alamos National Laboratory found halide perovskite semiconductors (silver) treated with a thin layer of cesium (blue-green) could be tuned to emit free electrons (gray) over both the visible and ultraviolet spectrum (colored arrows), and that a fresh layer of cesium could regenerate degraded photocathodes.
Image courtesy A. Mohite/Rice University
Rice, Los Alamos make low-cost, scalable photocathodes from halide perovskites
Rice University engineers have discovered technology that could slash the cost of semiconductor electron sources, key components in devices ranging from night-vision goggles and low-light cameras to electron microscopes and particle accelerators.
In an open-access Nature Communications paper, Rice researchers and collaborators at Los Alamos National Laboratory (LANL) describe the first process for making electron sources from halide perovskite thin films that efficiently convert light into free electrons.
Manufacturers spend billions of dollars each year on photocathode electron sources made from semiconductors containing rare elements like gallium, selenium, cadmium and tellurium.
“This should be orders of magnitude lower in cost than what exists today in the market,” said study co-corresponding author Aditya Mohite, a Rice materials scientist and chemical engineer. He said the halide perovskites have the potential to outperform existing semiconductor electron sources in several ways.
“First, there’s the combination of quantum efficiency and lifetime,” Mohite said. “Even through this was a proof-of-concept, and the first demonstration of halide perovskites as electron sources, quantum efficiency was only about four times lower than that of commercially available gallium arsenide photocathodes. And we found halide perovskites had a longer lifetime than gallium arsenide.”
Another advantage is that perovskite photocathodes are made by spin coating, a low-cost method that can easily be scaled up, said Mohite, an associate professor of chemical and biomolecular engineering and of materials science and nanoengineering.
“We also found that degraded perovskite photocathodes can be easily regenerated compared to conventional materials that usually require high-temperature annealing,” he said.
The researchers tested dozens of halide perovskite photocathodes, some with quantum efficiencies as high as 2.2%. They demonstrated their method by creating photocathodes with both inorganic and organic components, and showed they could tune electron emission over both the visible and ultraviolet spectrum.
Quantum efficiency describes how effective a photocathode is at converting light to useable electrons.
“If each incoming photon generates an electron and you collected every electron, you would have 100% quantum efficiency,” said study lead author Fangze Liu, a postdoctoral research associate at LANL. “The best semiconductor photocathodes today have quantum efficiencies around 10-20%, and they are all made of extremely expensive materials using complex fabrication processes. Metals are also sometimes used as electron sources, and the quantum efficiency of copper is very small, about .01%, but it’s still used, and it’s a practical technology.”
The cost savings from halide perovskite photocathodes would come in two forms: the raw materials for making them are abundant and inexpensive, and the manufacturing process is simpler and less expensive than for traditional semiconductors.
“There is a tremendous need for something that is low-cost and that can be scaled up,” Mohite said. “Using solution-processed materials, where you can literally paint a large area, is completely unheard of for making the kind of high-quality semiconductors needed for photocathodes.”
The name ‘perovskite’ refers to both a specific mineral discovered in Russia in 1839 and any compound with the crystal structure of that mineral. Halide perovskites are the latter, and can be made by mixing lead, tin and other metals with bromide or iodide salts.
Research into halide perovskite semiconductors took off worldwide after scientists in the United Kingdom used sheetlike crystals of the material to make high-efficiency solar cells in 2012. Other labs have since shown the materials can be used to make LEDs, photodetectors, photoelectrochemical cells for water-splitting and other devices.
Mohite, an expert in perovskites who worked as a research scientist at LANL prior to joining Rice in 2018, said one reason the halide perovskite photocathode project succeeded is that his collaborators in LANL’s Applied Cathode Enhancement and Robustness Technologies research group are “one of the best teams in the world for exploring new materials and technologies for photocathodes.”
Photocathodes operate according to Einstein’s photoelectric effect, releasing free electrons when they are struck by light of a particular frequency. The reason quantum efficiencies of photocathodes are typically low is because even the slightest defects, like a single atom out of place in the crystal lattice, can create “potential wells” that trap free electrons.
“If you have defects, all your electrons are going to get lost,” Mohite said. “It takes a lot of control. And it took a lot of effort to come up with a process to make a good perovskite material.”
Mohite and Liu used spin-coating, a widely used technique where liquid is dropped onto a rapidly spinning disk and centrifugal force spreads the liquid across the disk’s surface. In Mohite and Liu’s experiments, spin-coating took place in an argon atmosphere to limit impurities. Once spun, the disks were heated and placed in high vacuum to convert the liquid into crystal with a clean surface.
“It took a lot of iterations,” Mohite said. “We tried tuning the material composition and surface treatment in many ways to get the right combination for maximum efficiency. That was the biggest challenge.”
He said the team is already working to improve the quantum efficiency of its photocathodes.
“Their quantum efficiency is still lower than state-of-the-art semiconductors, and we proposed in our paper that this is due to the presence of high surface defects,” he said. “The next step is to fabricate high-quality perovskite crystals with lower surface defect densities.”
###
Additional co-authors include Siraj Sidhik and Pulickel Ajayan of Rice; Mark Hoffbauer, Sina Lewis, Amanda Neukirch, Vitaly Pavlenko, Hsinhan Tsai, Wanyi Nie, Sergei Tretiak, Jared Crochet and Nathan Moody of Los Alamos; Jacky Even of the Institute of Electronics and Digital Technologies in Rennes, France; and Mercouri Kanatzidis of Northwestern University. The research was supported by the Army Research Office, Rice University and the Institut Universitaire de France.
Links and resources:
The DOI of the Nature Communications paper is: 10.1038/s41467-021-20954-6
A copy of the paper is available at:
https:/
High-resolution IMAGES are available for download at:
https:/
CAPTION: Artist’s representation of a halide perovskite photocathode. Researchers at Rice University and Los Alamos National Laboratory found halide perovskite semiconductors (silver) treated with a thin layer of cesium (blue-green) could be tuned to emit free electrons (gray) over both the visible and ultraviolet spectrum (colored arrows), and that a fresh layer of cesium could regenerate degraded photocathodes.
(Image courtesy A. Mohite/Rice University)
https:/
CAPTION: Aditya Mohite
(Photo by Jeff Fitlow/Rice University)
https:/
CAPTION: Fangze Liu
(Photo courtesy of F. Liu)
This release can be found online at news.rice.edu.
Follow Rice News and Media Relations via Twitter @RiceUNews.
Located on a 300-acre forested campus in Houston, Rice University is consistently ranked among the nation’s top 20 universities by U.S. News & World Report. Rice has highly respected schools of Architecture, Business, Continuing Studies, Engineering, Humanities, Music, Natural Sciences and Social Sciences and is home to the Baker Institute for Public Policy. With 3,978 undergraduates and 3,192 graduate students, Rice’s undergraduate student-to-faculty ratio is just under 6-to-1. Its residential college system builds close-knit communities and lifelong friendships, just one reason why Rice is ranked No. 1 for lots of race/class interaction and No. 1 for quality of life by the Princeton Review. Rice is also rated as a best value among private universities by Kiplinger’s Personal Finance.
Related Journal Article
All latest news from the category: Materials Sciences
Materials management deals with the research, development, manufacturing and processing of raw and industrial materials. Key aspects here are biological and medical issues, which play an increasingly important role in this field.
innovations-report offers in-depth articles related to the development and application of materials and the structure and properties of new materials.
Newest articles
How marine worms regenerate lost body parts
The return of cells to a stem cell-like state as the key to regeneration. Many living organisms are able to regenerate damaged or lost tissue, but why some are particularly…
Nano-scale molecular detective
New on-chip device uses exotic light rays in 2D material to detect molecules. Researchers have developed a highly sensitive detector for identifying molecules via their infrared vibrational “fingerprint”. Published in Nature…
Novel CAR T-cell therapy
… demonstrates efficacy and safety in preclinical models of HER2-positive solid tumors. The p95HER2 protein is found expressed in one third of HER2+ tumors, which represent 4% of all tumors….