"Spintronics" could enable a new generation of electronic devices

Moore´s Law – a dictum of the electronics industry that says the number of transistors that fit on a computer chip will double every 18 months – may soon face some fundamental roadblocks. Most researchers think there´ll eventually be a limit to how many transistors they can cram on a chip. But even if Moore´s Law could continue to spawn ever-tinier chips, small electronic devices are plagued by a big problem: energy loss, or dissipation, as signals pass from one transistor to the next. Line up all the tiny wires that connect the transistors in a Pentium chip, and the total length would stretch almost a mile. A lot of useful energy is lost as heat as electrons travel that distance.

Theoretical physicists at Stanford and the University of Tokyo think they´ve found a way to solve the dissipation problem by manipulating a neglected property of the electron – its “spin”, or orientation, typically described by its quantum state as “up” or “down.”

They report their findings in the Aug. 7 issue of Science Express, an online version of Science magazine. Electronics relies on Ohms Law, which says application of a voltage to many materials results in the creation of a current. That´ because electrons transmit their charge through the materials. But Ohm´s Law also describes the inevitable conversion of electric energy into heat when electrons encounter resistance as they pass through materials.

“We have discovered the equivalent of a new `Ohm´s Law´ for spintronics – the emerging science of manipulating the spin of electrons for useful purposes,” says Shoucheng Zhang, a physics professor at Stanford. Professor Naoto Nagaosa of the University of Tokyo and his research assistant, Shuichi Murakami, are Zhang´s co-authors. “Unlike the Ohm´s Law for electronics, the new `Ohm´s Law´ that we´ve discovered says that the spin of the electron can be transported without any loss of energy, or dissipation. Furthermore, this effect occurs at room temperature in materials already widely used in the semiconductor industry, such as gallium arsenide. That´s important because it could enable a new generation of computing devices.”

Zhang uses a celestial analogy to explain two important properties of electrons – their center of mass and their spin: “The Earth has two kinds of motion. One is that its center of mass moves around the Sun. But the other is that it also spins by itself, or rotates. The way it moves around the Sun gives us the year, but the way it rotates around by itself gives us the day. The electron has similar properties.” While electronics uses voltage to move an electron´s center of mass, spintronics uses voltage to manipulate its spin.

The authors predict that application of an electric field will cause electrons´ spins to flow together collectively in a current. The applied electric force, the spins and the spin current align in three different directions that are all perpendicular to each other.

“This is a remarkable thing,” explains Zhang. “I push you forward and you move sideways – not in the direction that I´m pushing you.”

So far, only superconductors are known to carry current without any dissipation. However, extremely low temperatures, typically -150 degree Celsius, are required for the dissipationless current to flow inside a superconductor. Unlike electronic superconductors being investigated in advanced laboratories throughout the world, whose operating temperatures are too low to be practical in commercial devices, Zhang, Nagaosa and Murakami theorize that the dissipationless spin current will flow even at room temperature.

“This [the work reported in the paper] is a theoretical prediction,” Zhang says. “The next step is to work closely with experimental labs to verify this prediction and to demonstrate this effect.” That will require creating materials and testing them with a sensitive spin detector. “Once this is done we can go ahead to propose different device structures which take advantage of this effect,” he says.

Zhang characterizes his work as fundamental research but says spintronics is already making its way into devices in other labs. With lack of dissipation, spintronics may be the best mechanism for creating ever-smaller devices. The potential market is enormous, he says. “In maybe a 10-year timeframe, spintronics will be on par with electronics,” he predicts. “That´s why there´s a huge race going on around the world.”

The National Science Foundation and the Department of Energy in the United States and the Ministry of Education, Culture, Sports, Science and Technology in Japan funded the work.

Contact: Dawn Levy, +1-650-725-1944, dawnlevy@stanford.edu

Media Contact

Dawn Levy EurekAlert!

All latest news from the category: Power and Electrical Engineering

This topic covers issues related to energy generation, conversion, transportation and consumption and how the industry is addressing the challenge of energy efficiency in general.

innovations-report provides in-depth and informative reports and articles on subjects ranging from wind energy, fuel cell technology, solar energy, geothermal energy, petroleum, gas, nuclear engineering, alternative energy and energy efficiency to fusion, hydrogen and superconductor technologies.

Back to home

Comments (0)

Write a comment

Newest articles

First-of-its-kind study uses remote sensing to monitor plastic debris in rivers and lakes

Remote sensing creates a cost-effective solution to monitoring plastic pollution. A first-of-its-kind study from researchers at the University of Minnesota Twin Cities shows how remote sensing can help monitor and…

Laser-based artificial neuron mimics nerve cell functions at lightning speed

With a processing speed a billion times faster than nature, chip-based laser neuron could help advance AI tasks such as pattern recognition and sequence prediction. Researchers have developed a laser-based…

Optimising the processing of plastic waste

Just one look in the yellow bin reveals a colourful jumble of different types of plastic. However, the purer and more uniform plastic waste is, the easier it is to…